首先补丁包来自凌云实验室：

1.先打补丁：
patch -p1 < ../linux-3.0-s3c2440.patch

2.修改
Makefile：
ARCH            ?= arm
CROSS_COMPILE   ?= arm-linux-

3.修改补丁的错误：
在/arch/arm/plat-s3c24xx/devs.c
//#ifdef CONFIG_SND_SOC_SAMSUNG_S3C24XX_UDA134X  /* UDA1341 add by guowenxue, 2012.03.30 */  //注释掉
.
.
.
//#endif

4.make s3c2410_defconfig

5.裁剪内核，太大内核时，解压内核时出错：
去掉对 SMDK2410/A9M2410 的选中后
 │     -> System Type                                                                                                                      
  │       -> S3C2410 Machines
 │     -> System Type                                                                                                                       
  │       -> S3C2412 Machines
 │     -> System Type                                                                                                                      │  
  │       -> S3C2416 Machines
里面的所有全部去掉


这个部分去掉：
     -> System Type                                                                                                                      │  
  │       -> S3C2440 and S3C2442 Machines
 │                               [ ] Simtec Electronics ANUBIS                                                                         │ │  
  │ │                               [ ] Openmoko GTA02 / Freerunner phone                                                                 │ │  
  │ │                               [ ] Simtec IM2440D20 (OSIRIS) module                                                                  │ │  
  │ │                               [ ] HP iPAQ rx3715                                                                                    │ │  
  │ │                               [*] SMDK2440                                                                                          │ │  
  │ │                               [ ] NexVision NEXCODER 2440 Light Board                                                               │ │  
  │ │                               [*] SMDK2440 with S3C2440 CPU module                                                                  │ │  
  │ │                               [ ] SMDM2440 with S3C2442 CPU module                                                                  │ │  
  │ │                               [ ] Avantech AT2440EVB development board                                                              │ │  
  │ │                               [ ] MINI2440 development board                                                                        │ │  
  │ │                               [ ] HP iPAQ rx1950  
留上面的
 │     -> System Type                                                                                                                      │  
  │       -> S3C2443 Machines
里面的所有全部去掉


6.make zImage
最后裁剪到：
Data Size:    2300708 Bytes = 2246.79 kB = 2.19 MB
还是比较大，暂时能用了。

7.问题：
一直没有打印信息原来是这个原因
(不同版本内核对应的U-BOOT参数还不一样)：
uboot设置的串口参数有问题，如下设置。

setenv bootargs 'console=ttyS0'
save


还好顺利启动了，